Known for reliability, innovation, and focus on miniature pneumatics, Clippard's new Cordis electronic pressure controls (EPC) utilize the proven EVP and DVP lines of electronic proportional valves allowing for steady, repeatable downstream pressure as demand or processes change. The result, a precise linear pressure control within a closed-loop system with ultra high resolution and repeatability.
The Cordis uses a microcontroller, integrated pressure sensor, and two Clippard proportional valves. The inlet valve is connected to the moderately regulated supply pressure and the exhaust valve is connected to a port that vents excess pressure to atmosphere. Once a command is increased, the inlet valve opens up to allow supply pressure to pass over the sensor element which provides an active feedback for this microcontroller to satisfy the set point in the process. If at any point the sensor detects a value higher than the set point, the exhaust valve will modulate open to vent off the excess pressure to maintain a stable and accurate control pressure in the process.
The Cordis pressure regulators are adaptable to a variety of sensors that can close the loop around not only pressure, but vacuum or flow.
**NOTE** | Consult Clippard for Custom Calibrated Ranges |
---|---|
2D File | 2D File |
Accessories | 3.3 VDC Serial Cable, 3': CPCH-C2, Power Cord, 6': CPCH-CA6, Actuation Cable, 8-Pin, 6': CPCH-C1, Mounting Bracket: CPCH-B1 |
Accuracy | ±0.25% of Full Scale |
Applications Form | Applications Form |
Calibrated Range | 0 to 60 psig |
Current | <250 mA max. |
Data Sheet | Data Sheet |
Function | Normally-Closed Proportional |
Length | 4.54 |
Linearity | ±0.05% BFSL |
Max. Hysteresis | ±0.05% of Full Scale |
Medium | Clean, Dry, Non-Corrosive Gases |
Min. Volume / Flow @ Max. Pressure | ≥2.00 in3 / 65.0 l/min |
Mounting Attitude | Any |
Operating Instructions | Operating Instructions |
Operating Pressure | Vac. to 150 psig (10 bar) |
Porting | 1/8" NPT |
Product Line Brochure | Cordis Electronic Controls |
Protection Rating | IP65 |
Resolution | ≤5 mV |
Response Time | <20 ms Typical (Application Dependent) |
Signal/Command | 3.3 VDC Serial |
Temperature Range | 32 to 120°F (0 to 49°C) proportional valves |
Troubleshooting Guide | Troubleshooting Guide |
Type | Housed Unit, Internal Sensor |
Typical Flow | 2.7 to 65 l/min (±10% @ 100 psig [7 bar]) |
Weight | 0.5 |
Weight | 0.5 |
Knowledge Base
Applications
- Precision Control Solutions for Commercial Inkjet Printing
- Vacuum Control (Inline, Low Flow)
- Flow Cytometry Pressure Control
- 3D Printing (Positive Pressure)
- Chemical Mechanical Planarization (CMP)
- Pressure Control for 3D Bioprinting (Vacuum)
- Pressure Driven Flow Control
- Low Pressure Leak Testing
- Gas Chromatography
- Vacuum Control (Generator)
Product Information
- Cordis CPC Electronic Pressure Controls FAQ
- Resolution in Proportional Control
- Digital vs. Analog Control in Proportional Applications
Product Tips
Troubleshooting
Videos
- The Proportional Valves at the Heart of Clippard's Cordis Series Electronic Pressure Controller
- How to Plumb Clippard's Cordis Pressure Controller for Vacuum
- Pressure Sensor Ranges for the Cordis CPC Series Electronic Pressure Regulators
- Key Differentiators of Clippard's Cordis Electronic Proportional Pressure Controls
- Fluid Power World Video Interview: Cordis Electronic Pressure Regulators
- Clippard's CMO & COO Discuss New Cordis Series
- 6 Ways Clippard's New Cordis EPR is Revolutionizing Electronic Pressure Control
- How to Precisely Control Head Pressures of Liquids with Clippard's Cordis Series
- Products That Provide Proportional Control of Vacuum
- A Comparison of Mechanical Regulators vs. Electronic Regulators