Search

Search results

1. Stability vs. Fill-Time in Proportional Control Applications

   ... situation is due to improper valve sizing allowing too much air to pass over the sensor element. In general, achieving pressure quickly ... command, the inlet valve opens to allow a slug of compressed air to pass over the sensing element. Due to the restricted volume, the slug of ...

2. History: 1940s

   ... resulting in the device's initial use over water or in the air as to ensure it either detonated or was lost, unable to be recovered intact ... solution. Cylinders on each corner of the device, driven by air, would power the needles enough to make good contact with the coil and ...

3. Building a Billion-Cycle Valve

   ... of a two-way valve, especially a manifold-mount valve, air enters through the bottom, flows into the valve, then makes a 180° turn ... out against the bumper. In the manifold-mount version, air then flows through the #10-32 port, through the orifice, and into the ...

4. Precise, Consistent Control Supports Cell Proliferation

   ... of this process is sparging, which is the introduction of air, oxygen, carbon dioxide, and nitrogen to the cell culture media. ... series valves were selected to be used to control oxygen, air, carbon dioxide, and nitrogen being fed through the bioreactor’s sparger ...

5. Fill & Bleed Applications

   ... use a fill and bleed type circuit to add or subtract air in maintaining pressure. They can also be referred to as E/P or ... where a pneumatic fill and bleed circuit is controlling the air pressure in a flexible bladder built into a seat. Massage or therapy chairs ...

6. Pneumatic Security

   ... ETO valve . This electronic/pneumatic valve then sends air to a Clippard Modular valve , which then sends air to a  Clippard Stainless Steel Cylinder located inside the door. ...

7. Clippard Maximatic® Line of Valves & FRLs Press Release

   ... 3-way, 4-way, single and double solenoid, 3-way and 4-way air piloted valves are available in many sizes and variations for a wide range ... options. This all-new line of Maximatic solenoid valves, air piloted vales, and FRL’s offer many possibilities for users in the ...

8. Clippard Analytical Valve Cleaning Specification

   ... that is kept under positive pressure with HEPA filtered air.         (Seals are cleaned and out-gassed in a separate area.) ... purified water, then dried with heat and/or forced (ambient) air or compressed nitrogen. Post-Cleaning Inspection •   ...

9. Clippard Manifold Mounted Multi Check Valves

   ... more. • Efficient design • Eight air passages extend longitudinally through the body   surrounding the ... diverter or as a 2-way selector. Media:  Air, Water or Oil Flow:  255 l/min @ 100 psig Pilot ...

10. Clippard Gasket & Sealant Tips

    ... are applied wet and harden when no longer exposed to air. their proper use results in a very effective, low cost seal. There are ... first two methods will provide adequate sealing for normal air pressures. When extra resistance to vibration is necessary or a permanent ...

Pages