CHP-HFE-5MI

More Views

CHP-HFE-5MI

The Cordis uses a microcontroller, integrated pressure sensor, and two Clippard electronic valves. The inlet valve is connected to the moderately regulated supply pressure and the exhaust valve is connected to a port that vents excess pressure to atmosphere. Once a command is increased, the inlet valve opens up to allow supply pressure to pass over the sensor element which provides an active feedback for the microcontroller to satisfy the set point in the process. If at any point the sensor detects a value higher than the set point, the exhaust valve will modulate open to vent off the excess pressure to maintain a stable and accurate control pressure in the process.
Estimated to ship within 10 business days
Quantities and lead times are changing daily due to supply chain challenges. We appreciate your patience and understanding.
Contact your local Clippard Distributor for volume discounts.

  • Smooth linear control
  • Integrated internal or external sensor feedback
  • Static applications
  • Customizable pressure ranges and mounting options

  • **NOTE**Consult Clippard for Custom Calibrated Ranges
    2D Files2D Files
    Accessories8-Pin Actuation Cable, 6': CPCH-C1, 3.3 VDC Serial Cable, 3': CPCH-C2, Mounting Bracket: CPCH-B2
    Accuracy±0.5% of full scale
    Calibrated Range0 to 34 bar
    Current Draw<250 mA max.
    Data SheetData Sheet
    Filtration40 micron (recommended)
    FunctionNormally-Closed
    Linearity≤0.2%
    Max. Hysteresis≤0.25%
    Max. Inlet550 psig (38 bar) ≤500 psig (34.5 bar), 1100 psig (76 bar) ≥501 psig
    MediumClean, Dry, Non-Corrosive Gases
    Min. Volume/Flow @ Max. Pressure≥2.00 in3 / 12.5 l/min
    Mounting AttitudeAny
    Operating InstructionsOperating Instructions
    Operating PressureVac. to 1,000 psig (69 bar)
    Operating Temperature Range32 to 180°F (0 to 82°C)
    Port Size1/8" NPT
    Protection RatingIP65
    Resolution≤50 mV
    Response Time<20 ms Typical (application dependent)
    Signal/Command0 to 10 VDC
    TypeHoused Unit
    Weight1.0800
    Get CAD files: